How to Use the Coritec 450i Dental Milling Machine
How to Use the Coritec 450i Dental Milling Machine
The Coritec 450i is a computer-controlled precision milling machine that can produce dental restorations from various non-metal materials. It has a compact table-top design, a rigid steel-aluminum construction, and a five-axis machining system. It also features an automated tool changer, a blank holder, a high-frequency spindle, and a suction unit. In this article, we will explain how to set up and operate the Coritec 450i dental milling machine.
Coritec 450i manual
Set-up and Initial Operation
Before using the Coritec 450i, you need to make sure that you have the following requirements:
A stable and level surface to place the machine
A power supply of 115 V or 230 V
A compressed air supply of at least 7 bar and 50 l/min
A PC with the control software installed
A USB cable to connect the PC and the machine
The appropriate tools and materials for your milling project
To set up the machine, follow these steps:
Place the machine on the surface and secure it with screws.
Connect the power cord to the machine and plug it into a power outlet.
Connect the compressed air hose to the machine and turn on the air supply.
Connect the USB cable to the PC and the machine.
Open the door of the machine and insert the blank into the blank holder. Make sure that it is aligned correctly.
Close the door of the machine and lock it with the key.
Turn on the power switch on the back of the machine.
Turn on the PC and launch the control software.
Select the milling program that matches your material and design.
Calibrate the tool length sensor by following the instructions on the screen.
Milling Process
To start the milling process, follow these steps:
Press the start button on the control software.
The machine will automatically select the appropriate tool from the tool changer and start milling.
You can monitor the progress of the milling on the screen.
When the milling is finished, you will hear a beep sound.
Open the door of the machine and remove the finished restoration from the blank holder.
Clean the restoration with a brush or compressed air.
Clean the inside of the machine with a vacuum cleaner or compressed air.
Troubleshooting
If you encounter any problems with the Coritec 450i, you can refer to the user manual[^1^] for more detailed information. Some common issues and solutions are:
ProblemSolution
The machine does not start or stops during operation.Check if there is a power outage or a loose connection. Check if there is an error message on the screen. Check if there is enough compressed air supply. Check if there is any obstruction in the spindle or tool changer. Restart the machine and try again.
The milling quality is poor or inaccurate.Check if you have selected the correct milling program. Check if you have calibrated the tool length sensor. Check if you have inserted
the blank correctly. Check if you have used a suitable tool for your material. Replace
the tool if it is worn or damaged. Check if there is any dust or debris in
the machine. Clean
the machine regularly.
The spindle makes abnormal noises or vibrations.Check if there is any damage or wear on
the spindle. Check if there is any foreign object in
the spindle holder. Check if there is enough cooling air for
the spindle. Contact
the manufacturer or service provider for repair or replacement.
The suction unit does not work properly.Check if there is any blockage or leakage in
the suction hose. e0e6b7cb5c